LED-Akustikwand, dekorative COB-Streifen, Touch-dimmbar, Wand-/Hintergrundleuchte, Regal-/Unterschrankleuchte, Schlafzimmer-Nachtlicht

Specification: Lighting Color: Neutral White/Warm White/white LED Strip Type: COB;320Pcs/M PCB Width：8MM Color Temperature: Warm White (2800K-3000K)/Neutral White(4000k-5000K)/white(6000k-6500k) Length:100CM/200CM/300CM/500CM(can be customized,per 2.5cm can be cuttable) Switch Type:Penetrable Wood Hand Sweep and Stepless Touch Dimmer Switch Penetrating Wood Detection Range:<=25MM Input Voltage: AC100V-240V Power Adapter: EU Plug / US Plug Features: A)1-6 rolls of COB LED strip parallel: 1M/2M/3M/5 LED COB are installed in parallel and controlled by a single sensor, the number of light beads is dense, so that high brightness and low energy consumption, creating a warm and inviting environment, suitable for acoustic panel lighting, showcase lighting, wall panels lighting, cabinet, kitchen lighting and shelf lighting other indoor scenes B)Hand scanning and touch sensor switch: the sensor comes with glue, stick the sensor on the partition (≤2.5cm), you can control the cob LED strips by touching and hand scanning, a short press can control the cob LED to turn on and off, a long press can adjust the brightness of the LED strip warm white, very convenient. Meanwhile, the sensor has a memory function that saves your time to reset. C)Hidden sensor switch: the sensors are suitable for cabinets, showcases and other cabinets that need to be equipped with hidden sensor switches that you can stick to the back of wooden partitions or glass mirrors without opening holes. Note: the thinner the divider, the higher the sensitivity of the control. It is recommended that the control area of the divider is within 25MM Keep them away from metallic materials. D)Light strip LED COB self-adhesive, can be cut: cob LED comes with adhesive backing, installation is more convenient and concise. Please wipe the surface to be installed before installing the light bar to make the adhesion better. The strip can be cut along the centre line of the 2-pin copper piece (every 2 cm), you can cut it according to the installation requirements. Note: Do not install the sensor on metallic materials to avoid interference. ② For higher sensitivity, a thickness of the divider of ≤25MM is recommended. ③ When cutting, cut along the centre line of the 2-pin copper sheet and disconnect the power supply before cutting. ④ Please do not stick the backing material repeatedly so that the adhesion of the adhesive does not decrease.